Landmark Metalcoat uses a proprietary composite metal that is 95% metal mixed with a 5% binder that is cold-sprayed onto virtually any substrate to create the look and feel of solid cast metal. This metal is applied as part of a proprietary seven-step process.

At an average 10-mil thickness (plating is less than 1-mil thick) our metalcoating adds less than four ounces of weight per square foot, provides the durability of solid cast metal and is non-corrosive. Our metalcoating and urethane substrate has a Class 1-Class A fire rating.

Our proprietary metalcoated urethane substrate may be used for interior and exterior applications. All products can be easily cut or mitered using a wet or dry saw. The metal will not chip, flake or peel from any cutting or drilling. Field tile or tile with low relief may also be used for floor application. Tile may be used in a shower or pool area, around a cooktop, behind a backsplash and range hood and around fireplaces. For installation we recommend a high quality interior/exterior multi-purpose thin-set mortar. All types of grout may be used but care must be used for epoxy grout - no acidic clean up. Apply a two-part epoxy if using tile as an onlay over existing stone or ceramic tile. Tile may also be glued to metal or wood hood ranges and wood cabinets using a mastic or wood bond. Run a clear bead of silicone around outside to keep moisture out. Refer to Installation for more information.

Product installed in wet areas should be wiped dry with a soft cloth to prevent spotting. Use Gojo® sparingly to remove water spots and unwanted green patina. A moisture-repelling product (like Rain-X®) can be used to protect tile installed above the water line in or around a pool. There is no maintenance required for tile installed below the water line. The metalcoating has a living finish and will age naturally over time.